![]() After you have connected the Camera 2.0, please wait until the status LED above the camera lens flashes in the cycle "short, short, long" and only then click on "Continue" *1) | ![]() Read through the text and then click on "Continue". | ![]() After you have scanned or entered the code, click "Continue. | ![]() Please read through the text. You can access the WLAN settings via the settings of your smartphone. Attention: If you are using an iOS device (Apple), a message window pops up (see picture below). Please click on "Join", then you will get to point 8 (points 5, 6 and 7 are skipped). |
![]() Select your Camera 2.0 here. The name of the camera always starts with GIGASET-8cae89xxxxxx . After successful login, the camera name will say "Connected - No Internet". Then go back to the elements app. | ![]() Shortly after the Camera 2.0 is connected to your smartphone, a message window pops up. Click on the message window. | ![]() Confirm with "YES" that you want to keep this Internet connection and then click on "Continue". | ![]() On this page, select the WLAN network (WLAN router) to which you want to connect the camera and then click on "Continue". |
![]() Enter the network key of your WLAN router here and then click on "Continue". Please also check the password you have entered (If you click on the "eye", you will see your entry). | ![]() When this window appears, please wait approx. 20 seconds until you click on "Continue". | ![]() Now it may take some time until you reach the point where you specify in which "room" the camera is to be used, if you have already created rooms, and then click on "Continue". | ![]() Here you enter the name of the camera (e.g. Camera Living Room) and then click on "Continue". |
![]() Please enter the correct time zone where the camera is to be used and then click on "Continue". | ![]() Finally, click on "Finish" | ||
*1) If the LED doesn't flash in the cycle "short, short, long", the camera must be reset.
| ![]() |